FAQs

Several issues could cause a water heater to stop producing hot water, such as a faulty heating element, a tripped circuit breaker, or a broken thermostat. Check these components and replace them if necessary. If you’re unsure or uncomfortable doing this yourself, contact a professional plumber for assistance.

A running toilet is usually caused by a faulty flapper valve or a fill valve. You can try adjusting the chain on the flapper valve or replacing the flapper valve altogether. If the fill valve is the issue, consider replacing it to stop the toilet from running continuously.

A dripping faucet is often caused by a worn-out or damaged washer or O-ring. To fix this issue, you can try replacing the washer or O-ring. If you’re not comfortable doing this yourself, consider contacting a plumber for assistance.

Foul odors are often caused by food particles and grease buildup in the disposal. To eliminate the odor, try grinding ice cubes and citrus peels in the disposal to clean the blades and freshen the unit. You can also run hot water and a mild detergent down the disposal to remove any remaining residue.

Leaks can occur due to damaged seals, loose connections, or cracks in the disposal unit. First, identify the source of the leak. Tighten any loose connections and replace any damaged seals. If the leak persists, you may need to replace the disposal unit.

Before attempting to fix a jammed disposal, make sure to turn off the power to the unit. You can then use a disposal wrench or an Allen wrench to manually rotate the blades and free the jam. Once the jam is cleared, restore power to the disposal and test it.

Several reasons could cause this issue, such as a tripped circuit breaker, a blown fuse, a faulty switch, or a jammed disposal. Try resetting the disposal by pressing the reset button located on the bottom of the unit. If that doesn’t work, check the circuit breaker and the power supply to the disposal.

Small cracks or chips can be repaired using a bathtub repair kit available at most hardware stores. Follow the instructions carefully to ensure a proper repair. For larger cracks or significant damage, it’s advisable to consult a professional for repair or replacement options.

Slow drainage is often caused by a buildup of hair, soap scum, or mineral deposits in the drain. You can try using a mixture of baking soda and vinegar followed by hot water to clear the blockage. If this doesn’t work, consider using a drain snake or contacting a plumber for assistance.

You can try using a plunger or a drain snake to clear minor clogs. For tougher clogs, a chemical drain cleaner may be effective, but be cautious and follow the manufacturer’s instructions. If the clog persists, it’s best to call a professional plumber.